Light parameters

The Ford F-250 has 2 light parameters.

● Confirmed◆ In testing○ Supported× Not supported

How to read a parameter card

Bit 0 of the reply.

States
Raw value	State
`0`	`0`
`216`	`1`

In testing for 1999, 2002 to 2005, 2007 to 2009, 2012 to 2015, 2018. Not supported for 2000 to 2001, 2006, 2010 to 2011, 2016 to 2017, 2019 to 2026.

The parameter's name and its ID in the OBDb. Confirmed shows when a response from a real car confirms the parameter.
The clutch mark shows a Connectable, a parameter that Pelican surfaces in its interface.
The service and PID/DID asked for, the control module it's sent to, and how often Pelican asks.
The reply's bytes. The parameter's bytes are blue. Bytes for other parameters in the same reply are grayed out. Hover over a byte to see the parameter it represents.
Where the parameter is in the response, and how Pelican converts the raw value into a value.
A real reply, decoded. The raw value comes first, then the reading.
Which model years have tested this parameter.

Bit 0 of the reply.

States
Raw value	State
`0`	`0`
`216`	`1`

In testing for 1999, 2002 to 2005, 2007 to 2009, 2012 to 2015, 2018. Not supported for 2000 to 2001, 2006, 2010 to 2011, 2016 to 2017, 2019 to 2026.

Bits 0 to 15 of the reply, 16 bits.

In testing for 1999, 2002 to 2005, 2007 to 2009, 2012 to 2015, 2018. Not supported for 2000 to 2001, 2006, 2010 to 2011, 2016 to 2017, 2019 to 2026.