Subaru Impreza

Light parameters

The Subaru Impreza has 1 light parameter.

● Confirmed◆ In testing○ Supported× Not supported

How to read a parameter card

Stop light switch IMPREZA_STOP_LIGHT_SWITCH

  • Request22 12 30
  • Service 22DID 1230
  • Module7A2 → 7AA
  • Every1 s
  • Testing for 1992 to 2014, 2016 to 2026

Bits 0 to 7 of the reply, 8 bits.

Formula
val
Range
0 to 255
Unit
Number

In testing for 1992 to 2001, 2003 to 2007, 2016 to 2017, 2022, 2026. Supported for 2015. Not supported for 2002, 2008 to 2014, 2018 to 2021, 2023 to 2025.

  1. The parameter's name and its ID in the OBDb. Confirmed shows when a response from a real car confirms the parameter.
  2. The clutch mark shows a Connectable, a parameter that Pelican surfaces in its interface.
  3. The service and PID/DID asked for, the control module it's sent to, and how often Pelican asks.
  4. The reply's bytes. The parameter's bytes are blue. Bytes for other parameters in the same reply are grayed out. Hover over a byte to see the parameter it represents.
  5. Where the parameter is in the response, and how Pelican converts the raw value into a value.
  6. A real reply, decoded. The raw value comes first, then the reading.
  7. Which model years have tested this parameter.

Stop light switch IMPREZA_STOP_LIGHT_SWITCH

  • Request22 12 30
  • Service 22DID 1230
  • Module7A2 → 7AA
  • Every1 s
  • Testing for 1992 to 2014, 2016 to 2026

Bits 0 to 7 of the reply, 8 bits.

Formula
val
Range
0 to 255
Unit
Number

In testing for 1992 to 2001, 2003 to 2007, 2016 to 2017, 2022, 2026. Supported for 2015. Not supported for 2002, 2008 to 2014, 2018 to 2021, 2023 to 2025.

Keyboard shortcuts

jk/↓↑
Move down or up through a list or a grid.
hl/←→
Move across a row or between cards.
Enter
Open the focused link.
f
Open the current focus area's filter.
↓
In a filter, move to the first result.
Esc
Close a filter or a dialog.
?
Show these shortcuts.