Pelican
Get the app

Ford Fusion Energi

FUSIONENERGI_MAP parameters

The Ford Fusion Energi has 1 FUSIONENERGI_MAP parameter.

● Confirmed◆ In testing○ Supported× Not supported

How to read a parameter card

Manifold absolute pressure sensor voltage FUSIONENERGI_MAP_VConfirmed

Typically varies from 1 volt at idle to 5 volts during wide open throttle.

  • Request22 03 01
  • Service 22DID 0301
  • Module7E0 → 7E8
  • Every250 ms
  • Testing for 2013 to 2014, 2016, 2019 to 2020

Bits 0 to 15 of the reply, 16 bits.

Formula
(val × 0.0009765625)
Range
0 to 5 V
Unit
V

Confirmed for 2015, 2017 to 2018. In testing for 2013 to 2014, 2016, 2019 to 2020.

  1. The parameter's name and its ID in the OBDb. Confirmed shows when a response from a real car confirms the parameter.
  2. The clutch mark shows a Connectable, a parameter that Pelican surfaces in its interface.
  3. The service and PID/DID asked for, the control module it's sent to, and how often Pelican asks.
  4. The reply's bytes. The parameter's bytes are blue. Bytes for other parameters in the same reply are grayed out. Hover over a byte to see the parameter it represents.
  5. Where the parameter is in the response, and how Pelican converts the raw value into a value.
  6. A real reply, decoded. The raw value comes first, then the reading.
  7. Which model years have tested this parameter.

Manifold absolute pressure sensor voltage FUSIONENERGI_MAP_VConfirmed

Typically varies from 1 volt at idle to 5 volts during wide open throttle.

  • Request22 03 01
  • Service 22DID 0301
  • Module7E0 → 7E8
  • Every250 ms
  • Testing for 2013 to 2014, 2016, 2019 to 2020

Bits 0 to 15 of the reply, 16 bits.

Formula
(val × 0.0009765625)
Range
0 to 5 V
Unit
V

Confirmed for 2015, 2017 to 2018. In testing for 2013 to 2014, 2016, 2019 to 2020.

Start your test drive today.

Download Pelican on the App Store

See all featuresCompare plansJoin the beta crew

Keyboard shortcuts

jk/↓↑
Move down or up through a list or a grid.
hl/←→
Move across a row or between cards.
Enter
Open the focused link.
f
Open the current focus area's filter.
↓
In a filter, move to the first result.
Esc
Close a filter or a dialog.
?
Show these shortcuts.